Eicon Networks V8.3 User Manual
Page 53
Dial-Up Networking and RAS Administration
53
4.
In the ‘Configuration’ dialog box, select ‘Remote access (dial-up or VPN)’.
Click ‘Next’.
5.
In the ‘Remote Access’ box, select whether the server should receive VPN and/or
dial-up connections.
Click ‘Next’.
6.
In the ‘IP Address Assignment’ box, specify whether IP addresses will be assigned to
remote clients automatically or from a specified range.
Click ‘Next’.
Note: If you select to assign the IP addresses from a specified range, enter the
address ranges in the following dialog boxes.
7.
If your computer is part of a network, the ‘Managing Multiple Remote Access Servers’
box is displayed.
Specify if you want to set up your RAS server to use an existing RADIUS server. By
default, the RADIUS server is not used.
The RADIUS (Remote Authentication Dial-In User Service) protocol is used for
managing remote user authentication and authorization in dial-up networks or virtual
private networks. If a RADIUS server is available in your LAN you can have your RAS
connections authenticated and monitored by this server. You do not need to create
your own remote access policies.
Click ‘Next’.
8.
Click ‘Finish’ to finish the ‘Routing and Remote Access Server Setup Wizard’.