Emerson Process Management Bristol ControlWave ExpressPAC - Manual (Page 72)

ControlWave ExpressPAC Instruction Manual (CI-ControlWave EPAC)
7.
When the FLASH is ready for download, HyperTerminal
repeatedly displays the letter C on the screen. In the
HyperTerminal menu bar click Transfer > Send File (see
Figure 5-2).
Figure 5-2. HyperTerminal
(Ready to Download)
8.
In the Send File dialog box (see Figure 5-3), select 1KXmodem
for the protocol, enter the filename of the appropriate .bin file in
the format “E1Sxxxxx.bin” or “E3Sxxxxxx.bin” (where E1S
refers to 14 MHz CPUs, and E3S refers to 33 MHz CPUs and
xxxxx varies from release to release) and click Send to start the
flash upgrade (see Figure 5-4). When you see the
HyperTerminal Mode Menu again, it means the download has
completed.
9.
Exit HyperTerminal and power down the ControlWave
ExpressPAC. If desired, you can disconnect the null modem
cable between the ControlWave ExpressPAC and the PC.
10.
Set switch SW1-3 to the OFF position (OFF = Recovery Mode
Disabled).
11.
Restore power to the ControlWave ExpressPAC.
Figure 5-3. Send File dialog box
5-4 Service & Troubleshooting Revised Mar-2011