3 connecting power, Connecting power -7, Fastening the device to the rack – Enterasys Networks C1H124-24 User Manual
Page 35: Proceed to, Section 3.4.3
Installing the Device
Hardware Installation
3-7
2. With the mounting brackets attached, position the device between the vertical frame members
of the 19-inch rack as shown in
. Then fasten the device securely to the frame using
four mounting screws
(user supplied).
Figure 3-5
Fastening the Device to the Rack
3.4.3
Connecting Power
If you experience any problems with this installation, contact Enterasys Networks for assistance.
To connect the device to the power source, refer to
and proceed as follows:
1. Plug the power cord
into the switch ac power receptacle
.
2. Plug the other end of each power cord
into a dedicated grounded ac outlet
as shown in
.
Rails of 19-inch rack
Mounting screws (supplied by user)
NOTE: The power supply in the device has automatic voltage sensing that allows
connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac, 1.25 A,
50/60 Hz.
CPU RPS
1
16
17
32
33
48
49
51
2
3
4
5
6
7
8
9
10
1
1
12
13
14
15
18
19
20
21
22
23
24
25
26
27
28
29
30
31
34
35
36
37
38
39
40
41
42
43
44
45
46
47
50
52
1
2
47
48
52
50
49
51
V1H124-48
3831_00_05
Б
А