Everpure 327 - Manual (Page 29)

Cold Drink Center (327/328) Operator’s Guide
3280020 Page 23 August, 2003
Programming Procedures
GAIN ACCESS TO THE SUPERVISOR MODE
1. Press . The display shows: ENTER CODE . You must enter the four-
digit supervisor code within 6 seconds to gain access.
NOTE
A new machine has a factory-set supervisor code of 0000.
When you have entered the right code, you will hear two beeps and see
UNLOCKED
in the display.
2. CONTINUE.
ENTER A NEW SUPERVISOR CODE
1. Follow the steps in "Gain Access To The Supervisor Mode" on page 23.
2. Press . The display shows SUPER XXXX . The X's represent the
current supervisor code. Use the number keys to enter a new code.
NOTE
If you enter a new code, be sure to keep a written record of it.
There is no other way to access the SUPERVISOR mode.
3. CONTINUE.
ENTER A FREEVEND CODE
(Supervisor Mode Only)
1. Follow the steps in "Gain Access To The Supervisor Mode" on page 23.
2. Press , then until the display shows FREE XXXX . The X's
represent the current freevend code. Use the number keys to enter a new
code. If the code is anything other than "0000", it must be entered after the
key lock is turned in order to enable free vends.
3. CONTINUE.