Installation – Enviro Venice User Manual
Page 23
23
C-C
AST
C
ERAMIC
B
AFFLE
I
NSTALLATION
:
1. Slide the right C-Cast Ceramic Baffle in over the secondary air tubes at the top of the firebox. The tab
must be on the top and pointing towards the center and the smooth side is to face down.
Left Ceramic Baffle
Right Ceramic Baffle
Figure 23: Installation of C-Cast Ceramic Baffle.
Installation
F
AN
W
IRING
D
IAGRAMS
:
This appliance, when installed, must be electrically connected and grounded in accordance with local
codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part
1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI
/ NFPA 70 in the USA.
CAUTION Label all wires prior to disconnection when servicing controls. Wiring errors
can cause improper and dangerous operation. Verify proper operation after servicing.
DO oil the fan bearings regularly.
DO NOT cut or remove the grounding prong from the plug.
DO NOT route the power cord beneath the heater.
WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection against
shock hazard and should be plugged into a properly grounded three-prong receptacle.
2. Hook the outside edge of the baffle
over the top of the secondary air
chamber. This will make room to for the
installation of the left C-Cast Ceramic
Baffle.
3. Slide the left C-Cast Ceramic Baffle in
over the secondary air tubes. The tab
must be on the bottom and pointing
towards the center and the smooth side
is to face down.
4. Pull the baffles together in the middle
so the right tab rests on top of the left
tab. Ensure the baffles are flush with
the back and both sides of the firebox.
Note for insert models only: If the
bolts on the flue collar are not to the left
and right of the hole, the front secondary
air tube will need to be removed in order
to install or remove the C-Cast Ceramic
Baffles. To remove the front secondary
air tube place a screwdriver (any style
except flat head) into one of the air holes
and tapping it with a hammer/mallet to
the left.