Enviro Venice - Manual (Page 25)

Installation
R
EMOVAL
O
F
F
ACE
:
1. Remove the cast top from the unit
(lift up and forward)
2. Lift up and forward on the unit face,
the entire face and surround panel
will come away from the unit.
Figure 26: Removal of Face.
25
Figure 27: Installation of Panel.
I
NSTALLATION
O
F
T
HE
S
URROUND
P
ANEL
:
1. Loosen (but do not remove) the
four (4) 1⁄4” screws holding the
cast top.
2. List the cast top off the unit and
place to the side.
3. Loosen the four (4) torx T-20
screws holding the face on the
unit.
4. Lift the face up and forward to
remove from the unit.
5. Attach the surround panel to the
face using the eight (8) torx T-20
screws provided (four per side).
6. Replace the face on the unit
and tighten the four torx T-20
screws.
7. Replace the cast top on the unit.
The four (4) 1⁄4” screws can be
left loose.