Edge Products ES3528-WDM - Manual (Page 407)

negotiation
24-3
24
Default Setting
• Auto-negotiation is enabled by default.
• When auto-negotiation is disabled, the default speed-duplex setting is:
- Fast Ethernet ports – 100full (100 Mbps full-duplex)
- Gigabit Ethernet ports – 1000full (1 Gbps full-duplex)
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• To force operation to the speed and duplex mode specified in a speed-duplex
command, use the no negotiation command to disable auto-negotiation on
the selected interface.
• When using the negotiation command to enable auto-negotiation, the
optimal settings will be determined by the capabilities command. To set the
speed/duplex mode under auto-negotiation, the required mode must be
specified in the capabilities list for an interface.
• 100BASE-BX ports are fixed at 100 Mbps, full-duplex.
• The 1000BASE-T standard does not support forced mode. Auto-negotiation
must always be used to establish a connection over any 1000BASE-T port or
trunk.
Example
The following example configures port 5 to 100 Mbps, half-duplex operation.
Related Commands
negotiation (24-3)
capabilities (24-4)
negotiation
This command enables autonegotiation for a given interface. Use the no form to
disable autonegotiation.
Syntax
[no] negotiation
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface ethernet 1/5
Console(config-if)#speed-duplex 100half
Console(config-if)#no negotiation
Console(config-if)#