Edge Products ES3528-WDM - Manual (Page 295)

File Management Commands
19-17
19
Example
The following example shows how to display all file information:
whichboot
This command displays which files were booted when the system powered up.
Syntax
whichboot
Default Setting
None
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the file or image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of configuration file or code image.
Console#dir
File name File type Startup Size (byte)
------------------------------------- -------------- ------- -----------
Unit1:
D1.0.0.7.bix Boot-Rom Image Y 1159752
V1.0.1.7.bix Operation Code Y 3542608
Factory_Default_Config.cfg Config File N 526
startup1.cfg Config File Y 3256
---------------------------------------------------------------------------
Total free space: 10223616
Console#
Console#whichboot
File name File type Startup Size (byte)
-------------------------------- -------------- ------- -----------
Unit1:
D1.0.0.7.bix Boot-Rom Image Y 1159752
V1.0.1.7.bix Operation Code Y 3542608
startup1.cfg Config File Y 3256
Console#