Edge Products ES3528-WDM - Manual (Page 315)

Time Commands
19-37
19
Command Mode
Global Configuration
Example
show logging sendmail
This command displays the settings for the SMTP event handler.
Command Mode
Normal Exec, Privileged Exec
Example
Time Commands
The system clock can be dynamically set by polling a set of specified time servers
(NTP or SNTP). Maintaining an accurate time on the switch enables the system log
to record meaningful dates and times for event entries. If the clock is not set, the
switch will only record the time from the factory default set at the last bootup.
Console(config)#logging sendmail
Console(config)#
Console#show logging sendmail
SMTP servers
-----------------------------------------------
192.168.1.19
SMTP minimum severity level: 7
SMTP destination email addresses
-----------------------------------------------
[email protected]
SMTP source email address: [email protected]
SMTP status: Enabled
Console#
Table 19-14 Time Commands
Command Function Mode Page
sntp client Accepts time from specified time servers GC 19-38
sntp server Specifies one or more time servers GC 19-39
sntp poll Sets the interval at which the client polls for time GC 19-39
show sntp Shows current SNTP configuration settings NE, PE 19-40
clock timezone Sets the time zone for the switch’s internal clock GC 19-40
calendar set Sets the system date and time PE 19-41
show calendar Displays the current date and time setting NE, PE 19-42