Edge Products ES3528-WDM - Manual (Page 331)

show snmp view
20-11
20
show snmp view
This command shows information on the SNMP views.
Command Mode
Privileged Exec
Example
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views. Use
the no form to remove an SNMP group.
Syntax
snmp-server group groupname {v1 | v2c | v3 {auth | noauth | priv}}
[read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
• groupname - Name of an SNMP group. (Range: 1-32 characters)
• v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
• auth | noauth | priv - This group uses SNMPv3 with authentication, no
authentication, or with authentication and privacy. See “Simple Network
Management Protocol” on page 5-1 for further information about these
authentication and encryption options.
• readview - Defines the view for read access. (1-64 characters)
• writeview - Defines the view for write access. (1-64 characters)
• notifyview - Defines the view for notifications. (1-64 characters)
Console#show snmp view
View Name: mib-2
Subtree OID: 1.2.2.3.6.2.1
View Type: included
Storage Type: permanent
Row Status: active
View Name: defaultview
Subtree OID: 1
View Type: included
Storage Type: volatile
Row Status: active
Console#
Table 20-3 show snmp view - display description
Field Description
View Name Name of an SNMP view.
Subtree OID A branch in the MIB tree.
View Type Indicates if the view is included or excluded.
Storage Type The storage type for this entry.
Row Status The row status of this entry.