Edge Products ES3528-WDM - Manual (Page 530)

IP Interface Commands
35-2
35
Command Usage
• You must assign an IP address to this device to gain management access
over the network or to connect the switch to existing IP subnets. You can
manually configure a specific IP address, or direct the device to obtain an
address from a BOOTP or DHCP server. Valid IP addresses consist of four
numbers, 0 to 255, separated by periods. Anything outside this format will not
be accepted by the configuration program.
• If you select the bootp or dhcp option, IP is enabled but will not function until
a BOOTP or DHCP reply has been received. Requests will be broadcast
periodically by this device in an effort to learn its IP address. (BOOTP and
DHCP values can include the IP address, default gateway, and subnet mask).
• You can start broadcasting BOOTP or DHCP requests by entering an ip dhcp
restart command, or by rebooting the switch.
Notes: 1. Only one VLAN interface can be assigned an IP address (the default
is VLAN 1). This defines the management VLAN, the only VLAN
through which you can gain management access to the switch. If you
assign an IP address to any other VLAN, the new IP address
overrides the original IP address and this becomes the new
management VLAN.
2. Before you can change the IP address, you must first clear the
current address with the
no form of this command.
Example
In the following example, the device is assigned an address in VLAN 1.
Related Commands
ip dhcp restart (35-3)
ip default-gateway
This command specifies the IP default gateway for destinations not found in the local
routing tables. Use the no form to remove a default gateway.
Syntax
ip default-gateway gateway
no ip default-gateway
gateway - IP address of the default gateway
Default Setting
No static route is established.
Command Mode
Global Configuration
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#