Silvercrest SSR 1080 B2 - Manual (Page 124)

Satellite Receiver SSR 1080 B2
122 - English
DiSEqC 1.1
DiSEqC 1.1 allows up to 16 different satellites to be received. If
using DiSEqC 1.1 you can assign a port for every satellite position
selected. If you’re not using DiSEqC 1.1, select “Off”.
Transponder
Choose a transponder for the satellite selected. You can use the
Signal Intensity and Signal Quality indicators to verify that all
settings are correct.
Motor
If you have a motor-driven antenna system, press the [Red] button
(39) to set it up. Please also see the User Manual for your antenna
motor.
We cannot provide any further descriptions at this stage, as the
individual settings for each motor-driven antenna are very specific.
The following additional functions are available:
TP Search
To scan an individual transponder selected under “Transponder”
press the [Green] button (38).
Select the channels that you want to scan under “Search Range”.
The following options are available: “All Channel”, “Free Channel”,
“Scrambled Channel” and “TV Only”.
Under “Network Search”, choose whether you want to carry out a
network search or not.
Under “Search Mode”, specify whether you want to enter the
settings for “Video PID”, “Audio PID” and “PCR PID” manually or if
you want to find them automatically.
Press the [Blue] button (22) to start the search for the selected
transponder.
Name
Press the [Yellow] button (23) to rename the satellite. Press the
navigation buttons (26) on the remote control to select the desired
characters. Press the OK/ENTER button (25) to apply the character.
Press the [Green] button (38) to delete the character or press the
[Yellow] button (23) to erase the entire entry. Use the [Blue] button
(22) to display a different character map. Press the [Blue] button
(22) again to return to the previous character map. Press the [Red]
button (39) to save the entry.
Scan
Press the [Blue] button (22) to perform a channel search. For more
information, please read the „Automatic search satellite“ chapter on
page 120.