Silvercrest SNM 33 B1 - Manual (Page 75)

GB / IE 75
Getting ready
Connecting machine to power source
Disconnect the machine from the power
supply by removing the plug from the main
socket!
1. Loosen screw (A) as illustrated.
2. Remove the cover (B).
3. Unscrew the bulb and fit new one (C).
4. Replace the cover and tighten screw.
Should there be any problem. Ask your
local dealer for advice.
Changing the bulb
A
B
C
Attention:
Attention:
Sewing light
Foot control
Unplug power cord when machine is not
in use.
Consult a qualified electrician if in doubt
as to connect machine to power source.
Unplug power cord when machine is not
in use.
The foot control must be used with the
appliance by KD-2902 (220-240V area)
Connect the machine to a power source as
illustrated.
Press main switch (A) for power and light
on. (" l ")
Foot control regulates the sewing speed.
.
A A