Silvercrest SNM 33 B1 - Manual (Page 91)

GB / IE 91
Trouble shooting guide
Maintenance
Problem Cause Correction
Upper thread
breaks
Lower thread
breaks
Skipped
stitches
Needle breaks
Loose stitches
Seams gather
or pucker
Uneven stitches,
uneven feed
The machine is
noisy
The machine
jams
1.The machine is not threaded correctly.
2.The thread tension is too tight.
3.The thread is too thick for the needle.
4.The needle is not inserted correctly.
5.The thread is round wound the spool
pin cap.
6.The needle is damaged.
1.The bobbin case is not inserted
correctly.
2.The bobbin case is threaded wrongly.
1.The needle is not inserted correctly.
2.The needle is damaged.
3.The wrong size needle has been
used.
4.The foot is not attached correctly.
1.The needle is damaged.
2.The needle is not correctly inserted.
3.Wrong needle size for the fabric.
4.The wrong foot is attached.
1.The machine is not correctly threaded.
2.The bobbin case is not correctly
threaded.
3.Needle/ fabric/ thread combination is
wrong.
4.Thread tension wrong.
1.The needle is too thick for the fabric.
2.The stitch length is wrongly adjusted.
3.The thread tension is too tight.
1.Poor quality thread.
2.The bobbin case is wrongly
threaded.
3.Fabric has been pulled.
1.The machine must be lubricated.
2.Fluff or oil have collected on the
hook or needle bar.
3.Poor quality oil has been used.
4.The needle is damaged.
Thread is caught in the hook.
1.Rethread the machine.
2.Reduce the thread tension. (lower number)
3.Select a larger needle.
4.Remove and reinsert the needle. (flat side
towards the back)
5.Remove the reel and wind thread onto reel.
6.Replace the needle.
1.Remove and reinsert the bobbin case and
pull on the thread. The thread should pull
easily.
2.Check both bobbin and bobbin case.
1.Remove and reinsert needle. (flat side
towards the back)
2.Insert a new needle.
3.Choose a needle to suit the thread and
fabric.
4.Check and attach correctly.
1.Insert a new needle.
2.Insert the needle correctly. (flat side
towards the back)
3.Choose a needle to suit the thread and
fabric.
4.Select the correct foot.
1.Check the threading.
2.Thread the bobbin case as illustrated.
3.The needle size must suit the fabric and
thread.
4.Correct the thread tension.
1.Select a finer needle.
2.Readjust the stitch length.
3.Loosen the thread tension.
1.Select a better quality thread.
2.Remove bobbin case and retread and
insert correctly.
3.Do not pull on the fabric while sewing, let
it be taken up by the machine.
1.Lubricate as described.
2.Clean the hook and feed dog as described.
3.Only use good quality sewing machine oil.
4.Replace the needle.
Remove the upper thread and bobbin case,
turn the handwheel backwards and forwards
by hand and remove the thread remands.
Lubricate as described.