Silvercrest SNM 33 B1 - Manual (Page 79)

1
GB / IE 79
Getting ready
Threading the upper thread
Attention:
Set the main switch to ("O")!
Raise the sewing foot bar set by lifting
the 2-step sewing foot lever and put the
thread lever into its highest position by
turning the hand wheel counterclockwise.
Follow the arrow sand numbers on the
machine when threading.
1. Place the spool (m) on the spindle and
hold it in place with the spool pin cap (r).
- Small spool pin cap for thin threads
- Big spool pin cap for thick threads
2. Guide the upper thread through the
upper thread guide from right to left, then
place it forward into the right slot and
lead it downwards.
3. Guide it to the left under the guide lug (A)
and then upwards again.
4. Guide the thread from right to left
through the thread lever and then
downwards.
5. Guide the thread first behind the large,
metal thread guide (B) and the through
the eye of the needle. Always thread the
needle from the front.
Needle threader
You can use the needle threader as a
knitting aid.
1. Insert the needle threader through the
eye of the needle from back to front.
2. Guide the upper thread through the wire
loop of the needle threader.
3. Pull the needle threader together with
the thread back through the eye of the
needle.
2 3
4 5
1 2 3
A
B