Extreme Networks Summit1 - Manual (Page 73)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 4-1
4 Configuring Ports
Ports on the Summit switch can be configured in the following ways:
• Enabling and disabling individual ports
• Configuring the port speed (Fast Ethernet ports only)
• Configuring half- or full-duplex mode
• Creating load-sharing groups on multiple ports
• Configuring a port to connect to the Summit Virtual Chassis
• Changing the Quality or Service (QoS) setting for individual ports
For more information on QoS, refer to Chapter 8 .
E
NABLING AND
D
ISABLING
P
ORTS
By default, all ports are enabled. To enable or disable one or more ports, use the
following command:
[enable | disable] port <portlist>
For example, to disable ports 3, 5, and 12 through 15 on the Summit2, enter the
following:
disable port 3,5,12-15
Even though a port is disabled, the link remains enabled for diagnostic purposes.
Summit.bk : 4PORTS.FM Page 1 Thursday, June 18, 1998 9:27 AM