Extreme Networks Summit1 - Manual (Page 75)

S UMMIT S WITCH I NSTALLATION AND U SER G UIDE 4-3
P ORT C OMMANDS
P
ORT
C
OMMANDS
Table 4-1 describes the port commands.
Table 4-1: Port Commands
Command Description
enable learning port <portlist> Enables MAC address learning on one or more
ports. The default setting is enabled.
enable port <portlist> Enables a port.
enable sharing <master_port> grouping
<portlist> Defines a load-sharing group of ports. The ports
specified in <
portlist > are grouped to the
master port.
enable smartredundancy <portlist> Enables the smart redundancy feature on the
redundant Gigabit Ethernet port. When the smart
redundancy feature is enabled, the switch
always uses the primary link when the primary
link is available. The default setting is enabled.
config port <portlist> auto on Enables autonegotiation for the particular port
type; 802.3u for 10/100 Mbps ports or 802.3z for
Gigabit Ethernet ports.
config port <portlist> auto off {speed [10 |
100]} duplex [half | full] Changes the configuration of a group of ports.
Specify the following:
■ auto off — the port will not autonegotiate
the settings
■ speed — the speed of the port (for 10/100
Mbps ports only)
■ duplex — the duplex setting (half- or
full-duplex)
config port <portlist> qosprofile <qosname> Configures one or more ports to use a particular
QoS profile.
disable learning port <portlist> Disables MAC address learning on one or more
ports for security purposes. If MAC address
learning is disabled, only broadcast traffic and
packets destined to a permanent MAC address
matching that port number, are forwarded. The
default setting is enabled.
disable port <portlist> Disables a port. Even when disabled, the link is
available for diagnostic purposes.
disable sharing <master_port> Disables a load-sharing group of ports.
Summit.bk : 4PORTS.FM Page 3 Thursday, June 18, 1998 9:27 AM