EDGE Tech QL Series - Manual (Page 35)

35
QL Series User Guide
QL 420 Wireless Local Area Network (WLAN) Module Using
PCMCIA Radio
The following section only applies when the PCMCIA WLAN module (FCC ID: I28-
QL420352) is installed in the QL 420 printer (note that only one of the radio options
can be installed in the printer at one time). The FCC ID number label is on the front of
the module and can be read with the module installed.
WARNING: Use of the QL 420 with the radio module marked
with FCC ID: I28-QL420352 meets the FCC requirements for radio
frequency (RF) radiation exposure in the standard body worn
configuration with no minimum separation. In this configuration,
which applies whether the belt clip or shoulder strap is used, the
face of the printer from which paper is transported is facing away
from the user’s body. The standard configuration must always be
used when the printer is body worn. This configuration maintains
the required 1 cm separation distance.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was 1.04. W/kg averaged over 1
gram.
European Regulatory Information for this Radio
AUS B DK FIN
F D GR IRE
I LUX NL P
E S UK
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (
CH,
ICE, LI, NOR )
Europe EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE Directive
1999/5/EC. The following test methods have been applied in order to prove
presumption of compliance with the R&TTE Directive 1999/5/EC:
• EN 300 328-2 V1.3.1 (2001-12)- Technical requirements for spread-
spectrum radio equipment
• EN 301 489-17 V1.2.1 (2002-08)- EMC requirements for spread-spectrum
radio equipment
In France there are restrictions in the use of this device. A restricted
frequency band exists in France. When operating this device on French
0336
Important Notice:
This device is a portable RF printer intended for com-
mercial and industrial use in all EU and EFTA mem-
ber states except in France where restrictive use ap-
plies.
continued