EDGE Tech QL Series - Manual (Page 48)

48
QL Series User Guide
Use the supplied cleaning pen or 70%
isopropyl alcohol on a cotton swab to
clean the print elements from end to end
(the print elements are located in the thin
gray line on the printhead).
Printhead
(Figure 20)
Peel bar
(Figure 20)
Clean thoroughly with the cleaning pen
or 70% isopropyl alcohol and a cotton
swab.
Area Method Interval
As needed
After every five
rolls of media
(or more often,
if needed)
Platen
Roller
(Figure 20)
Rotate the platen roller and clean it
thoroughly with the cleaning pen or 70%
isopropyl alcohol and a cotton swab.
Units with linerless platens: Rotate
platen & clean bearing points only. Avoid
use of alcohol on the surface of linerless
platens!
Tear bar
(Figure 20)
Scraper
(Linerless units
only) Figure 20
Clean thoroughly with the cleaning pen or
70% isopropyl alcohol and a cotton swab.
Clean thoroughly with the
cleaning pen or 70% isopropyl
alcohol and a cotton swab.
Water-dampened cloth
Brush/air blow. Ensure the Bar Sensor, Gap
Sensor and Label Present Sensor windows
are free of dust.
As needed
After every five
rolls of media
(or more often,
if needed)
After every five
rolls of media
(or more often,
if needed)
Linerless media
requires more
frequent
cleaning
Interior
(Figure 20)
Units with linerless platens:
Clean inside surfaces of media disks & peeler
bar rollers with the supplied cleaning pen or
70% isopropyl alcohol on a cotton swab.
QL 320 Cleaning
Exterior