PRAKTICA luxmedia 16-Z24S - Manual (Page 107)

107
Playback
The color of the
playback image is
different from what
appears on the
monitor screen
when shooting. Sunlight or light from another source may be shining directly
into the lens when you are shooting. Position the camera so
sunlight does not shine directly into the lens.
Images are not
displayed. This camera cannot display non-DCF images recorded onto a
memory card using another digital camera.
Images cannot be
edited (with
resizing, trimming,
rotation). Note that you cannot edit the following types of snapshots.
• Movies
• Snapshots recorded with another camera
File Deletion
A file cannot be
deleted. 1)The file may be protected. Unprotect the file (page 68).
2)“
Disable” setting may be “On”. Change the setting to “Off”
(page 89).
Other
The wrong date
and time are
displayed, or the
wrong date and
time are being
stored along with
image data. The date and time setting is off. Set the correct date and time
(page 86).
The messages on
the display are in
the wrong
language. The wrong display language is selected. Change the display
language setting (page 87).
Images cannot be
transferred over a
USB connection. 1)The USB cable may not be connected securely. Check all
connections.
2)The wrong USB communication protocol is selected. Select
the correct USB communication protocol in accordance with
the type of device you are connecting (pages 76).
3)If the camera is not turned on, turn it on.
4)Your computer may not be able to recognize the camera if
you connect via a USB hub. Always connect directly to the
computer’s USB port.
Language selection
screen appears
when the camera is
turned on. 1)You did not configure initial settings after purchasing the
camera or the camera may have been left with a dead
battery. Check the camera setup (pages 18, 87).
2)There may be a problem with the camera’s memory data. If
this is the case, perform the reset operation to initialize the
camera’s setup (page 91). After that, configure each setting. If
the language selection screen does not re-appear when you
turn the camera on, it means that the camera’s memory
management data has been restored.
Problem Possible Cause and Recommended Action