PRAKTICA luxmedia 16-Z24S - Manual (Page 46)

46
4.
Press [SET] to configure the camera with the settings for the currently
selected scene.
This returns to the REC mode.
• The settings of the scene you selected remain in effect until you select a
different scene.
• To select a different Scene Mode scene, repeat the above procedure from
step 1.
5.
Press the shutter button (if you are shooting a snapshot) or [ ]
(Movie) (if you are shooting a movie).
• Using Scene Information Screen
To find out more about a scene, select it with the boundary
on the scene selection screen, and then slide the zoom
controller in either direction.
• To return to the scene menu, slide the zoom controller
again.
• To scroll between scenes, use [ ] and [ ].
• To configure the camera with the settings for the currently
selected scene, press [SET].
• Scene Mode Precautions
• Some Scene Mode scenes cannot be used while recording a movie.
• The Voice REC scene cannot be used while shooting a snapshot or recording a
movie.
• Since a slow shutter speed increases the chance of digital noise in the image, the
camera automatically performs a digital noise reduction process when either of
these scenes is selected. This means that it will take a bit longer for the image to
be saved which is indicated by the LED Lamp flashing green. Do not perform any
key operation during that time. Also, it is a good idea to use a tripod to avoid image
blur due to camera movement when shooting at slow shutter speeds.
• High Sensitivity
– The high sensitivity setting is disabled whenever the camera’s flash fires.
– High sensitivity may not produce the desired results in very dark conditions.
– When shooting with slow shutter speeds, use a tripod to protect against blurring
due to camera movement.
– Under certain lighting conditions, the camera will perform an automatic noise
filtering operation to reduce digital noise in the image. This operation causes the
camera to take longer than normal to save the image and be ready for the next
shot.
• Scene Mode scene images were not shot using this camera.
• Images shot using a Scene Mode scene may not produce the results you expected
due to shooting conditions and other factors.
• You can modify the camera settings that are made after you select a Scene Mode
scene. Note, however, that the Scene Mode settings will remember the last used
mode when you select another Scene Mode scene or turn off the camera.