Rose Electronics RackView Switch - Manual (Page 15)

SAFETY
Installation and Operations Manual 11
Safety
The Rackview Switch has been tested for conformance to safety regulations
and requirements. Like all electronic equipment, this Unit should be used
with care. To protect yourself from possible injury and to minimize the risk
of damage to the Unit, read and follow these safety instructions.
 Follow all instructions and warnings marked on this Unit.
 Except where explained in this manual, do not attempt to service this
Unit yourself.
 Do not use this Unit near water.
 Assure that the installation of this Unit in a 19” rack is secure and level
on all planes.
 Provide proper ventilation and air circulation.
 Keep power cord and connection cables clear of obstructions that might
cause damage to them.
 Use only power cords, power adapter and connection cables designed
for this Unit.
 Use only a grounded (three-wire) electrical outlet.
 Use only the power adapter provided with the Unit.
 Keep objects that might damage this Unit and liquids that may spill, clear
from this Unit. Liquids and foreign objects might come in contact with
voltage points that could create a risk of fire or electrical shock.
 Do not use liquid or aerosol cleaners to clean this Unit. Always unplug
this Unit from its electrical outlet before cleaning.
 Unplug this Unit from the electrical outlet and refer servicing to a
qualified service center if any of the following conditions occur:

The power cord or connection cables are damaged or frayed.

The Unit has been exposed to any liquids.

The Unit does not operate normally when all operating instructions
have been followed.

The Unit has been dropped or the case has been damaged.

The Unit exhibits a distinct change in performance, indicating a need
for service.