Subaru Robin SGX3500 - Manual (Page 25)

- 23 -
7. DISASSEMBLY AND ASSEMBLY
7-1 PREPARATION and PRECAUTIONS
(1) Be sure to memorize the location of individual parts when disassembling the generator so that
the generator can be reassembled correctly. Tag the disassembled part with the necessary
information to facilitate easier and smoother reassembly.
(2) For more convenience, divide the parts into several groups and store them in boxes.
(3) To prevent bolts and nuts from being misplaced or installed incorrectly, replace them
temporarily to their original position.
(4) Handle disassembled parts with care; clean them before reassembly using a neutral cleaning fluid.
(5) Remove the battery before disassembling the generator. (Electric start models)
(6) Use all disassembly/assembly tools properly, and use the proper tool for each specific job.
(7) Be sure to attach the foam rubber linings inside the covers on their original position when
reassembling the generator. When deformation or damage or falling-off of foam rubber lining
is found, replace it with new part. Failure to do so will result in poor performance and durability
of the generator.
(8) Bind the wires and fuel pipes using wire bands as they have been done in original configuration.
NOTE : As to detailed information for servicing procedures on engine portion, please refer to
Subaru engine service manual for "EX series".
7-2 DISASSEMBLY PROCEDURES
7-2-１ FUEL TANK
(1) Shut the fuel valve and discharge fuel from
fuel tank and carburetor.
(2) Disconnect rubber pipe from the strainer.
(3) Remove the fuel tank.
M6 flange bolt and nut . . . 4 pcs.
7-2-2 MUFFLER
(1) Remove the Muffler Cover.
Tapping screw . . . . . . . . . 2 pcs.
M5 Flange bolt and nut. . . . 2 pcs.