Subaru Robin SGX3500 - Manual (Page 28)

- 26 -
(5) Take off the through bolt of the rotor.
SGX3500 M8 X 195mm
SGX5000 M8 X 195mm
SGX7500 M8 X 252mm
(10) Use a bolt and oil as a tool for pulling out
rotor in the following procedures :
1. Pour engine oil into the center hole of rotor
shaft. Fill with oil to the shaft end.
2. Prepare a bolt with the following thread
size : M12 × 1.75 (SGX3500/5000/7500)
3. Apply a few turns of seal tape around the
tip of the bolt
4. Screw the bolt into the thread of the rotor
shaft.
5. Torque the bolt using a socket wrench
until the rotor comes off loose.
* The hydraulic pressure inside the rotor
shaft takes apart the rotor from the engine
shaft
(11) Remove the front cover.
M8 × 20 flange bolt . . . 4 pcs.