Subaru Robin SGX3500 - Manual (Page 37)

- 35 -
(3) Put on the stator with rear cover evenly
with a plastic hammer to press the rotor bearing
into the rear cover.
(3) Fix the rear cover with flange bolts.
flange bolt . . . 4 pc.
NOTE : Tighten the bolts evenly and in turns.
(4) Set the mount rubber bolts into the rear
cover holes.
Do not tighten the nut at this moment.
(5) Install the brush holder, AVR unit and wiring board
in the rear cover.
M5 × 16 bolt . . . 5 pcs.
(AVR unit, brush holder, wiring board)
NOTE : If the brush is installed oblique to the slip ring, there is possibility that the brush holder can
break when the screw is tightened : or the brush may break when generator of started.
Make this process carefully.
(6) Attach the connectors to the brush holder, AVR unit.
(7) Set the wires on the wiring board and tighten with
washers and nuts.
(8) Connect the earth (ground) wire (green) with the
rear cover at earth terminal with screw and washer.
(9) Connect earth (ground) wire between frame
and rear cover mount rubber nut (bolt).
On frame side: M6 × 12 bolt . . . 1 pc.
(commonly tighten the mount rubber bolt)
(SGX3500： Bolt)
BRUSH HOLDER
AVR UNIT
WIRING BOARD
EARTH TREMINAL