SAF-HOLLAND XL-TG10150UD TL and TG Series Liftgates - Manual (Page 18)

18 XL-TG10150UD-en-US Rev B · 2013-05-23 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Figure 27
Figure 29
Figure 28
Liftgate Operation Instructions
10. Stowing the Platform
IMPORTANT: There are two different travel latch options:
The HOOK option or the CHAIN option.
Determine which option you have
before proceeding.
Travel Hook Option
1. Lower the platform to below waist level, lift the end of
the flipover section, rotating it about the pivot bolts and
allow the flipover to fall onto the platform (Figure 27).
Failure to keep feet clear of platform
during operation could create a crush
and/or pinch hazard which, if not avoided,
could result in death or serious injury.
2. Lower the platform to the ground and rotate the inner
platform allowing it to rest against the platform roller
openers (Figure 28).
3. Stand clear and using the control station, raise the
platform until the lock pins are above the travel latch.
NOTE: When the liftgate is fully retracted to the stored
position, release the control switch.
4. Visually check to ensure that both lock pins are properly
engaged in the travel latch hooks (Figure 29).
ROLLER OPENERS
LATCH PIN
TRAVEL
LATCH
HOOK
FLIP OVER
SECTION
PIVOT BOLTS