Liftgate operation instructions – SAF-HOLLAND XL-TG10150UD TL and TG Series Liftgates User Manual
Page 19
19
XL-TG10150UD-en-US Rev B · 2013-05-23 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Figure 30
Figure 32
Liftgate Operation Instructions
Travel Chain Option
1. Lower the platform to below waist level, lift the end of
the flipover section, rotating it about the pivot bolts and
allow the flipover to fall onto the platform (Figure 30).
Failure to keep feet clear of platform
during operation could create a crush
and/or pinch hazard which, if not avoided,
could result in death or serious injury.
2. Lower the platform to the ground and rotate the inner
platform allowing it to rest against the platform roller
openers (Figure 31).
3. Stand clear and using the control station, raise the
platform until the platform is in fully raised position.
NOTE: When the liftgate is fully retracted to the stored
position, release the control switch.
4. Position the travel latch chain hook into the latch hook
hole in the side of the platform (Figure 32).
TRAVEL
LATCH
HOOK
HOLE IN
PLATFORM
FLIP OVER
SECTION
PIVOT BOLTS
Figure 31
ROLLER OPENERS