SAF-HOLLAND XL-TG10150UD TL and TG Series Liftgates - Manual (Page 20)

20 XL-TG10150UD-en-US Rev B · 2013-05-23 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Filling the Hydraulic Reservoir
Figure 33
Figure 35
Figure 34
11. Filling the Hydraulic Reservoir
IMPORTANT: Keep dirt, water, and other contaminants
from entering the hydraulic system; clean
the area to prevent contamination of the
hydraulic fluid and use a clean funnel with
a fine screen mesh.
1. Set the vehicle parking brake.
2. TG Models
Using the control station, put the platform in the up and
open position (Figure 33).
TL Models
Using the control station, put the platform in the down
and open position (Figure 34).
3. Remove the filler cap and add recommended hydraulic
fluid to pump reservoir. Check that the hydraulic fluid is
at the proper fill level (Figure 35).
IMPORTANT: Always use the correct grade of hydraulic
fluid. Refer to the chart below for
recommended hydraulic fluid or contact
your SAF-HOLLAND representative.
TEMPERATURE RECOMMENDED FLUIDS
RANGE MANUFACTURER TYPE
Above 0° C
(32° F)
Any
AW-32
ISO 32
-25 to 65° C
(-15 to 150 ° F) Any ESSO, EXXON
MOBIL, SHELL
HYDRAUL 50
DTE 11
DONAX TD
Low Viscosity
-35 to 50 ° C
(-30 to 120° F) EXXON, ESSO, SHELL,
PETRO-CAN
UNIVIS N15
TELLUS T15
MV ARCTIC 15
-45 to 40° C
(-50 to 100° F) Any ESSO, EXXON,
SHELL
MIL-H-5606
UNIVIS J-13
UNIVIS HV1 13
FLUID #4
TG MODEL IN UP
AND OPEN POSITION
TL MODEL IN DOWN
AND OPEN POSITION
FILLER CAP