Mounting instructions – SAF-HOLLAND XL-PH10412UM PH-995 Pin and Clevis Coupler User Manual
Page 11
11
XL-PH10412UM-en-US Rev A · 2011-10-28 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Mounting Instructions
Figure 14
Figure 15
Figure 13
Figure 12
5. Clean the interior of the housing then
wipe dry with a clean rag. Inspect
for cracks or damage. If cracked or
damaged obtain and install a new
housing (XA-749 or XA-749-1) before
proceeding. See Parts List, page 5.
6. Check mounting bolt torque:
a. Thru-bolt to the mounting structure:
Tighten four (4) 7/8" diameter Grade 8
bolts, ASTM Grade C lock nuts, and
hardened washers. Torque to 400 ft.-lbs.
/tN
(Figure 12).
b. Direct bolt to drilled and tapped
mounting structure:
Tighten four (4) 7/8" diameter Grade 8
bolts and torque to 400 ft.-lbs.
/tN
(Figure 13).
1SFQBSFUIFOFX1)4/
TVCBTTFNCMZ
7. Remove and retain the cotter pin
(XB-781-1) (Figure 14).
8. Remove and retain the castellated
nut (XB-780-1) (Figure 15).
TOP VIEW
#0-54
-0$,/654
"/%8"4)&34
#0-54
$055&3
1*/
$"45&--"5&%/65