Edirol V-44SW E1 - Manual (Page 44)

44
Using the V-44SW with Other Devices
You can link V-44SWs with an Edirol V-440HD in a system of up to six devices to display a single video source across
multiple screens. This function is referred to as “Multi-Screen Output.”
<Conceptual Image of Output>
■
Switching the V-44SW’s Operating Modes
To have the V-44SW function as a slave device to the V-440HD, you need to switch the V-44SW to “V-440HD Slave mode.”
1 Press the [MENU] button to display the Main menu.
2 Select “8. System” and select “12: V-440HD Slave Mode” from the sub-menu.
3 Set the parameter to “On.”
4 Turn the V-44SW’s power off, then on again.
Start up the V-440HD in Slave mode. At this time, all of the PANEL PRESET buttons light up in orange.
To return to the normal operating mode, select “13. System” from the menu and set “21: V-440HD Slave Mode” to “Off,”
then turn the V-44SW’s power off, then on again. The unit will start up in the normal mode.
● For more detailed instructions concerning use of Multi-Screen Output, refer to “Multi-Screen Output” in the V-440HD
Owner’s Manual.
● When V-440HD Slave mode is in use, the V-440HD’s menu includes the following additional parameters. For more
detailed information, refer to “Menu Parameters” in the V-440HD Owner’s Manual.
* The display “--------------------” indicates menu parameters that cannot be accessed from the V-44SW.
● The following buttons and knobs are enabled in V-440HD Slave mode.
[MIDI] button, [MENU] button, [ENTER] button, [CURSOR/VALUE] knob,
[1080i] button, [720p] button, [RGB] button
Using the V-44SW with a V-440HD for Multi-Screen Output
13. System Parameter Explanation Value
21: V-440HD Slave Mode Switches V-440HD on and off Off, On
● When using Multi-Screen Output, you must have a V-440HD as the master device. The V-44SWs function as slave
devices to the V-440HD.
Output Output Output
MIDI
V-440HD: Master
V-44SW: Slave1
MIDI
V-44SW: Slave1
V-44SW_e.book 44 ページ ２００６年１０月２３日 月曜日 午後３時２５分