Edirol V-44SW E1 - Manual (Page 49)

49
Using the V-44SW with Other Devices
You can back up and restore the V-44SW’s settings by
transmitting data between the V-44SW and a computer.
● This function requires software supporting backup and restore
procedures.
● With the V-44SW, use the “Serial Data Tool” software used in
backing up the V-440HD’s settings (for Windows XP only). This
software can be downloaded from the Roland Systems Group
website.
http://rolandsystemsgroup.net
Connect the computer and the V-44SW as shown in the
diagram below.
● Connect the computer using an RS-232C cable (D-Sub, 9-pin
female-female cross cable).
● If using the USB port, use a USB-to-serial adapter, and make the
settings necessary to ensure that the serial port functions
normally.
● For details of the pin assignments for the V-44SW’s REMOTE
connector, refer to “Connector Specifications: REMOTE
Connector” (p. 62).
● You can change the baud rate setting with “4: REMOTE
Baudrate” under “8. System” in the menu.
1 Using the computer, set the application so it is in a
standby state, waiting for data reception.
2 Press the [MENU] button to display the Main menu.
3 Select “8. System” and then select “9: All Data
Transmit” from the sub-menu.
4 Select “Yes.”
5 Press the [ENTER] button.
Transmission of the data begins. The progress of the
transfer is indicated at the bottom of the screen as a
percentage.
● Transfer of all of the data is completed in approximately 30
seconds.
● To cancel transmission while it is still in progress, press the
[MENU] button.
The V-44SW constantly receives data transmitted from the
computer. Use the computer’s software to transfer and restore
data to the V-44SW.
Backing Up the V-44SW’s
Settings to a Computer
Making the Connections
REMOTE
connector Serial port
V-44SW Rear Panel
RS-232C cable (cross)
Female Female
Computer
Procedure
Restoring Settings From a Computer
V-44SW_e.book 49 ページ ２００６年１０月２３日 月曜日 午後３時２５分