PLANET IPX-1900 - Manual (Page 24)

Port Num Analog Port Number (System Define)
Caller id
The caller ID will be sent between the callee and caller and will be
displayed on SIP device LCD panel for identification.
DID
Any calls originating from the registered ITSP to IP PBX will go into the
auto-attendant or direct to the selected user or hunting group.
Table 3-11. Trunk Management - FXO Trunk setup description
Gateway Trunk
Gateway Trunk Setting allows IP PBX makes VoIP calls to external Gateway by peer-to-peer mode. If
the FXO ports of external Gateway have connected with PSTN lines, the user can make outgoing
PSTN calls via external Gateway by this function.
Figure 3-15. Gateway Trunk setting
IP
Destination IP Address is the IP address of the destination
Gateway that owns this phone number.
Port Port is port of the destination Gateway use. (Default is 5060)
Table 3-12. Gateway Trunk setting description
Trunk Group
Trunk Group is defines the leading digit of the call out dialing number through SIP / FXO / Gateway
Trunks of the same type between two given points. The IP PBX will in according to the leading digit to
determine to use which SIP or Gateway Trunks for outgoing route.
Figure 3-16. Trunk Group setting - 1
Press “more” to show the Service Provider Number under the group.
24