PLANET SIP-50 - Manual (Page 9)

SIP-50 SIP Proxy Server User’s Manual
Install SIP Proxy Server to Your Network
- Choose an Installation Site
Select a suitable place on the network to install the SIP Proxy Server.
- Connect LAN Cables
Use standard LAN cables to connect your LAN side Switch or Hub to the LAN ports on SIP Proxy Server.
Both 10Base-T and 100Base-T connections can be used. The LAN and WAN port of SIP Proxy Server
support Auto-Negotiation to connect with best speed and duplex mode. The LAN port of SIP Proxy Server
is MDI port. Thus, you can just use straight network to connect the LAN port to your switch or hub.
- Power Up
Connect the supplied power cord to SIP Proxy Server and use the power switch that in rear panel to turn on
the SIP Proxy Server. Use only the power cord provided. Using a different one may cause hardware damage.
- Check the LEDs
The PWR LED should be ON. The STATUS LED should flash for about 1 to 2 minutes, then turn Off. This
LED will also flash when is reading data from the memory. The LAN’s LNK LED should be on. If the LED is
off, please check the network connection. In some case, you may need to use crossover cable to connect the
LAN port to your networks.
For more information, refer to Section 1.3 SIP Proxy Server Front View.
- 6 -