BenQ TH683 - Manual (Page 42)

Menu Functions 42
Switching input signal
The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time.
If you want the projector to always automatically search for the signals:
• Under the Advanced OSD menu, go to the System Setup : Basic menu, and enable
Auto Source. (see "Auto Source" on page 36 )
• Under the Basic OSD menu, if there’s no signal connected to the projector, go to
Auto Source and enable it; if there are signals connected, go to the Settings menu,
and then enable Auto Source. (see
"Auto Source" on page 36 and 37 )
You can also manually cycle through the available input signals.
1. Press SOURCE on the projector or press input source
directly from the remote control. A source selection bar
displays.
2. Press ▲/▼ until your desired signal is selected and press
OK.
Once detected, the selected source information will
display on the screen for seconds. If there is multiple
equipment connected to the projector, repeat steps 1-2 to
search for another signal.
• The brightness level of the projected image will change
accordingly when you switch between different input signals. Data (graphic) "PC"
presentations using mostly static images are generally brighter than "Video" using mostly
moving images (movies).
• The native display resolution of this projector is in a 16:9 aspect ratio. For best display
picture results, you should select and use an input signal which outputs at this resolution.
Any other resolutions will be scaled by the projector depending upon the 'aspect ratio'
setting, which may cause some image distortion or loss of picture clarity. See "Aspect Ratio"
on page 49 for details.
You can also rename the source:
1. Press MENU and then press ◄/► until the System Setup: Basic menu is
highlighted.
2. Press ▼ to highlight Source Rename and press OK. The Source Rename page
displays.
3. Press ▲/▼/◄/► until your desired character is selected and press OK.