BenQ TH683 - Manual (Page 63)

Maintenance 63
5. Loosen the captive screws that secure
the lamp.
• Do not turn the power on with the lamp
cover removed.
• Do not insert your fingers between the lamp
and the projector. The sharp edges inside the
projector may cause injuries.
6. Lift the handle so that it stands up. Use
the handle to slowly pull the lamp out of
the projector.
• Pulling it too quickly may cause the lamp to
break and scatter broken glass in the
projector.
• Do not place the lamp in locations where
water might splash on it, children can reach
it, or near flammable materials.
• Do not insert your hands into the projector
after the lamp is removed. If you touch the
optical components inside, it could cause
color unevenness and distortion of the
projected images.
7. Insert the new lamp into the lamp
compartment and make sure it fits in the
projector.
• Ensure the connectors are aligned.
• If you experience resistance, lift the lamp and
start again.
8. Connect the lamp connector and place
as drawing.
Lamp connector must be installed flush with the
connector base as shown in the image below. A
gap between the lamp connector and the
connector base will cause damage to the
projector. The following images illustrate correct
and incorrect lamp connector installations.
Correct Incorrect
Gap No Gap