Yamaha PSR-S770 - Manual (Page 108)

108 PSR-S970/S770 Reference Manual
9
Mixing Console
2
Use the [3 ]–[5 ] buttons to select a parameter then use the [6 ]/[7 ]
buttons to edit the value.
When Reverb, Chorus, or DSP1 is selected as the Effect Block, you can adjust the Return Level via the
[8 ] (RETURN LEVEL) button. If you want to change the Effect Type, use the [1 ]/[2 ]
buttons.
NOTE (PSR-S970) You can also edit the parameter on the display shown in step 1. Use the [D]/[I] or [E]/[J] buttons to select the desired parameter, then use the
[1
]–[8 ] buttons to adjust the Effect parameter value.
3
If DSP2, 3 or 4 is selected as the Effect Block, edit the Variation parameter if desired.
Press the [8 ] (VARI. DETAIL) button to call up the Variation parameter, select a parameter via the
[2 ]–[4 ] buttons, and then use the [5 ]/[6 ] buttons to edit the value. This parameter is
effective only when the [DSP VARI.] button lamp lights on the panel. To close this display, press the
[EXIT] button.
4
Press the [I] (SAVE) button to call up the display for the Save operation.
5
Use the [3
]–[5 ] buttons to select the destination for saving the settings as a
User Effect.
If necessary, change the User Effect name. Press the [6 ] (RENAME) button to call up the Character
Entry window, enter the name, and then press the [8 ] (OK) button.
6
Press the [8
] (OK) button to carry out the Save operation.
7
Press the [EXIT] button to return to the previous display.
The saved User Effect can be selected from the “User” category of the corresponding Effect Block
(
page 107 ).
2 3
4
5
6