Yamaha PSR-S770 - Manual (Page 37)

PSR-S970/S770 Reference Manual 37
2
St
yles
NOTE Intro 4 and Ending 4 can be selected on the display then created as your original Style although they are not available on the panel.
3
Replace the Source Pattern of the specific channel with that of another Style.
3-1
Select the desired channel to be replaced via the [A]–[D] and [F]–[I] buttons.
3-2
Press the same button of the selected channel to call up the Style Selection display.
3-3
Select the desired Style, then press the [EXIT] button to return to the original display.
3-4
Select the Section and Channel of the selected Style via the [2 ]–[5 ] buttons.
3-5
Confirm the sound with the newly assigned Source Pattern by pressing the STYLE CON-
TROL [START/STOP] button to play back the Style.
4
As desired, repeat step 3 for another channel.
NOTICE
The created Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation
(step 7 on
page 31 ).
Playing the Style During Style Assembly
You can play back the Style while you are assembling a Style, and the playback method can be selected.
In the ASSEMBLY page, use the [6 ]/[7 ] (PLAY TYPE) buttons to select the type.
• SOLO: Plays back the selected channel in the ASSEMBLY page. Any channels set to REC in the
RECORD display on the BASIC page are played back simultaneously.
• ON: Plays back the selected channel in the ASSEMBLY page. Any channels set to other than OFF in
the RECORD display on the BASIC page are played back simultaneously.
• OFF: Mutes the selected channel in the ASSEMBLY page.
3-1,
3-2
3-4
3-3
[A]–[D],
[F]–[I]
buttons