FujiFilm X-T1 - Manual (Page 72)

56
The DRIVE Dial
Continuous Shooting (Burst Mode) Continuous Shooting (Burst Mode)
Capture motion in a series of pictures.
1 Rotate the DRIVE dial to select CH (high-speed
burst) or CL (low-speed burst).
2 Take photographs. The camera will take pic-
tures while the shutter button is pressed;
shooting ends when the shutter button is re-
leased, the maximum number of pictures has
been taken, or the memory card is full.
R Frame rate varies with the subject, shutter speed,
sensitivity, and focus mode and may slow as more
shots are taken.
R The fl ash turns off automatically; the previously-se-
lected fl ash mode is restored when burst shooting
is disabled.
R Additional time may be required to record pictures
when shooting ends.
R If fi le numbering reaches 999 before shooting is
complete, the remaining pictures will be recorded
to a new folder (
P 93).
R In some drive modes, shooting may not begin if the
space available on the memory card is insuffi cient.
Focus and Exposure Focus and Exposure
To vary focus and exposure with each shot, select fo-
cus mode C; in other modes, focus and exposure are
determined by the fi rst shot in each series.
Q When CH is selected, the camera
focuses using the focus frames
shown at right.
Q Focus tracking performance var-
ies with aperture, sensitivity, and
shooting conditions.
1000 F3.3
CH mode focus frames