Eclipse - Fujitsu Ten ECLIPSE AVN726E - Manual (Page 61)

59 59
Most of the fields on this screen have a symbol next to them. This symbol shows whether the
field it is attached to is shown on the map as Trip Data. It also shows the position of the data as
follows:
Speedometer Shows the current speed both
graphically and as a number. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Distance Remaining Shows distance remaining to final
destination. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Time Remaining Shows the time needed to reach
the final destination of the route
based on information available for
the remaining segments of the
route. The calculation cannot take
into account traffic jams and other
possible delays. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Arrival Time Shows the estimated arrival time
at the final destination of the route
based on information available for
the remaining segments of the
route. The calculation cannot take
into account traffic jams and other
possible delays. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
GPS Time Shows the current time corrected
with time zone offset. The
accurate time comes from the
GPS satellites, and the time zone
information either comes from the
map or is set manually in Regional
settings. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Altitude Shows elevation if it is provided by
the GPS receiver. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Speed Limit Shows the speed limit of the
current road if the map contains it. Touch this field to show it on the
Map screen in one of the Trip Data
fields.
Trip Computer Opens a new screen with three
resettable Trip Computers.
Next Via Point Touch this switch to change the
content of the Route Data fields to
show information about the next
via point.
If you touch the previous switch,
this one replaces it.
[Destination] Touch this switch to have the
Route Data fields show
information about the final
destination again.
Name Description Function