Ashly mXa-1502 12-Channel 4-Zone DSP Mixer-Amplifier - Manual (Page 11)

6.2 Signal Chain
The core features of AquaControl are in its signal chain, where pluggable DSP blocks are placed
and edited as needed on input and output channels. Input signals can be routed into any of the four
mixers, then from the mixers to power amp outputs or the two aux outputs. The signal chain has an
Editor view and a Diagram view as shown below. Unused channels can be hidden from the display.
6.2e Presets
Presets and Sub-Presets are saved to the mXa-
1502 for scheduled or triggered recall.
6.2f Input DSP blocks
The following DSP functions are available on
input channels.
• Audio Meter
• Autoleveler
• Brick Wall Limiter
• Compressor
• DCA gain
• Delay
• Gain
• Gate
• Graphic Equalizer
• High-Pass Filter
• Low-Pass Filter
• Parametric Equalizer
• Signal Generator
• VCA Gain
6.2g Output DSP blocks
All input DSP blocks except for Feedback
Suppressor are available on output channels,
plus the following:
• Ambient Noise Compensation
• Crossover
• FIR Filter
6.2a Mic inputs 1-8
• Set Gain, +48V phantom power, mute, DSP.
Also see Settings>Panels>Rear Panel screen.
6.2b Stereo inputs 9-12
• Mute, DSP
6.2c Mixers 1-4
• Edit mixer routing, levels, ducker, automixer,
show/hide chains, add to sub-preset
6.2d Speaker & Aux 1-2
• Source mixer select, mute
11
mXa-1502 • Operating Manual Ashly AquaControl™ Software