Optoma ZU506T-W 5000-Lumen WUXGA Laser DLP Projector (White) - Manual (Page 21)

English 21
SETUP AND INSTALLATION
Effective range
Infra-Red (IR) remote control sensor is located on the top and front sides of the projector. Ensure to hold the
remote control at an angle within 60 degrees perpendicular to the projector’s IR remote control sensor to function
correctly. The distance between the remote control and the sensor should not be longer than 12 meters (39.4 feet).
‡ Make sure that there are no obstacles between the remote control and the IR sensor on the projector
that might obstruct the infra-red beam.
‡ Make sure the IR transmitter of the remote control is not being shined by sunlight or fluorescent lamps
directly.
‡ Please keep the remote controller away from fluorescent lamps for over 2 m or the remote controller
might become malfunction.
‡ If the remote control is close to Inverter-Type fluorescent lamps, it might become ineffective from time
to time.
‡ If the remote control and the projector are within a very short distance, the remote control might
become ineffective.
‡ When you aim at the screen, the effective distance is less than 5 m from the remote control to the
screen and reflecting the IR beams back to the projector. However, the effective range might change
according to screens.
F3
On
Geometric
Mode
Correction PIP/PBP
Off
F1 F2
AV Mute
ENTER
Source
Volume D Zoom
Info.
VGA
1
S-Video
2
HDMI1
3
HDMI2
HDMI3
FormatFreeze Remote
ID All
HDBaseT
4
Video
5
DVI
6 BNC
7
YPbPr
8
DisplayPort
9
3D
0
Re-Sync
Menu
F3
F3
On
Geometric
Mode
Correction
PIP/PBP
Off F1
F2
AV Mute ENTER Source
Volume
D Zoom
Info.
VGA 1 S-Video
2 HDMI1
3 HDMI2
HDMI3
Format
Freeze
Remote ID
All
HDBaseT
4
Video 5
DVI 6
BNC 7 YPbPr
8 DisplayPort
9
3D 0
Re-Sync
Menu
F3
Approx. ±30°
Approx. ±30°