Using the projector – Optoma ZU506T-W 5000-Lumen WUXGA Laser DLP Projector (White) User Manual
Page 35
English 35
USING THE PROJECTOR
Color Space (non-HDMI input only)
: Select an appropriate color matrix type from the following:
AUTO, RGB, or YUV.
Color Space (HDMI input only)
: select an appropriate color matrix type from the following: Auto,
RGB(0-255), RGB(16-235), and YUV.
White Level:
Allow user to adjust White Level when inputting Video signals.
Note:
White level can only be adjusted for Video/S-Video input sources.
Black Level:
Allow user to adjust Black Level when inputting Video signals.
Note:
Black level can only be adjusted for Video/S-Video input sources.
Saturation:
Adjust a video image from black and white to fully saturated color.
Note:
Saturation is only supported for VGA source (480i/480p 576i/675p 720P 1080i/1080p).
Hue:
Adjust the color balance of red and green.
Note:
Hue is only supported for VGA source (480i/480p 576i/675p 720P 1080i/1080p).
IRE:
Allow user to adjust IRE value when inputting Video signals.
Note:
IRE is only available with NTSC video format.
IRE can only be adjusted for Video/S-Video input sources.
Signal
Adjust the signal options.
Automatic
: Configure automatically the signal (the frequency and phase items are grayed out). If
automatic is disabled, the frequency and phase items will appear for tuning and saving the settings.
Frequency
: Change the display data frequency to match the frequency of your computer’s graphic
card. Use this function only if the image appears to flicker vertically.
Phase
: Synchronize the signal timing of the display with the graphic card. If the image appears to be
unstable or flickers, use this function to correct it.
H. Position
: Adjust the horizontal positioning of the image.
V. Position
: Adjust the vertical positioning of the image.
Note:
This menu is only available if the input source is RGB/Component.
Brightness Mode
Adjust the brightness mode settings.
DynamicBlack
: Use to automatically adjust the picture brightness in order to give optimum contrast
performance.
Power
: Choose the power percentage for brightness mode.
Reset
Return the factory default settings for color settings.