Enviro DV36 - Manual (Page 34)

Figure 56. Install Fan Control Box. Figure 57. Plug In Fan Kit.
34
Secondary Installation
Installation of Kit:
1. Ensure the appliance is turned off and cool.
2. Remove the bottom louvers.
3. Place fan in lower area of unit behind the controls (see Figure 54).
4. Hook the two (2) slots on the fan box over the two (2) grommets on the back wall, refer to Figure
55.
5. Using two (2) T-20 screws, attach the fan control box to the ignitor control panel, refer to Figure 56.
Before tightening the screws ensure that the thermal switch on top of the box firmly contacts the
firebox bottom.
6. Plug the fan into the hard wired electrical box/outlet (refer to Figure 57) that was installed in the
“I NITIAL I NSTALLATION - I NSTALLATION OF E LECTRICAL O UTLET F OR O PTIONAL F AN K I t“.
Figure 55. Hook Fan Tabs Over Grommets at Unit Back.