Henny Penny EEE-143 - Manual (Page 20)

Model EEE-141,142, 143, 144
1. Make sure basket support is in vat and the vat is filled with oil
to the proper level.
Model EEE-141, fill the oil reservoir. See Section 3-10.
2. Move power switch to the ON position and then press
to turn on heat for the desired vat. If display shows “IS POT
FILLED?” make sure oil is at the proper level (see Section
3-3) and then press
√√√√√
button for “YES”.
Unit automatically goes into the Melt Cycle until the oil tem-
perature reaches 180°F (82°C) and then control automatically
exits the Melt Cycle.
The Melt Cycle may be bypassed, if desired, by pressing
√√√√√
button or X button and holding it for 5 seconds.
The control then shows “EXIT MELT” “YES NO”.
Press
√√√√√ button for “YES” and vat heats continuously until the
set-point temperature is reached.
Do not bypass the Melt Cycle unless enough oil has melted
to completely cover all of the elements. If the Melt Cycle is
bypassed before all elements are covered, excessive
smoking of oil, or a fire will result.
DO NOT OVERLOAD, OR PLACE PRODUCT WITH
EXTREME MOISTURE CONTENT INTO THE
BASKETS. 3 LBS. (1.4 KG.) IS THE MAXIMUM
AMOUNT OF PRODUCT PER FULL VAT AND 1-1/2
LBS. (.68 KG.) FOR THE SPLIT VATS. FAILURE TO
FOLLOW THESE INSTRUCTIONS CAN RESULT IN
OIL OVERFLOWING THE VAT WHICH COULD
CAUSE SERIOUS BURNS, PERSONAL INJURY, FIRE
AND/OR PROPERTY DAMAGE.
3-4. MORNING START-UP
PROCEDURES
3-7 510