Henny Penny EEE-143 - Manual (Page 23)

Model EEE-141,142, 143, 144
3-10. MODEL EEE-141 OIL
RESERVOIR
Filling Oil Reservoir
1. Control displays “JIB IS LOW” and an alarm sounds.
2. Open door and pull reservoir forward and remove reservoir
cover. Figure 1.
3. Place on bracket on door. Figure 2.
4. Pour oil into reservoir upto the fill lines (13 lbs. (6.12 kg.)) and
then replace cover and push reservoir back into position.
Figure 3.
Removing/Cleaning Reservoir
1. Open door and pull reservoir forward.
2. Slide reservoir to the left and lift from fryer. Figure 4.
3. Clean reservoir at a sink with soap and water.
Before placing the reservoir back into position, lubricate the
o-rings (below) on the filter tube with cold oil. Check o-rings
for tears or nicks and replace if necessary.
To replace o-ring, use a small, flat-bladed screwdriver, pry up
on the o-ring and pull off of end of tube. See below.
Figure 1
Figure 2
Figure 3
Figure 4
510 3-10