Henny Penny EEE-143 - Manual (Page 37)

Model EEE-141,142, 143, 144
3-18. CHECK/REPLACE FILTER
DRAIN PAN O-RINGS
17. Thoroughly dry the vat with a towel, and then press the
√√√√√
button. Controls return to normal operations.
Make sure the inside of the vat, the drain valve opening,
and all the parts that come in contact with the new oil are
as dry as possible.
18. Make sure the drain is closed and return the filter pan assembly,
with new filter pad, to the fryer. Fill vat with oil following the
Filling or Adding Oil instructions from Section 3-3.
To prevent oil leaking, and to keep filtering process operating
properly, the filter drain pan o-rings should be inspected for nicks
and tears at least every 3 months. Figure 1
1. Open the door, lift-up on the drain pan stop and pull-out the
filter drain pan assembly, using the handle on the drain pan.
Figures 2 & 3
This pan could be hot! Use protective cloth or glove, or
severe burns could result.
2. Visually check the 3 o-rings on the tube of the filter drain pan
for any cracks or breaks and replace if necessary.
3. To replace o-ring, use a small, flat-bladed screwdriver, pry up
on the o-ring and pull off of end of tube. Roll new o-ring into
notch on tube. Before pushing the filter drain pan back into
position, lubricate the o-rings on the filter tube with fresh, cold
oil.
Figure 1
Figure 2
Figure 3
Figure 4
110 3-24
3-17. CLEAN-OUT MODE
(Continued)