Power, Power -4 – Honeywell DOLPHIN 9951 User Manual
Page 116
11 - 4
USB Port
This USB Port is full-speed and 2.0 compliant. Using a USB cable, you can connect the base
to a peripheral device, such as a workstation or printer. When the terminal is seated in the
terminal well, it is connected to the peripheral device via the base.
RS-232 Port
Use the 9-pin, RS-232 cable from Honeywell to connect this port to a peripheral device for RS-
232 data communication. For more information, see
DC Power Jack
Use the power cable from Honeywell that comes with the base to supply power to this power
jack. For more information, see
Power
section that follows
.
Power
The terminal requires 9.5 Volts DC input for communications and battery charging; the power adapter on
the power cable converts the voltage from the power source to 9.5 volts DC. Only the Honeywell 9.5 VDC
4A power supply provided with the base converts the voltage appropriately.
Honeywell recommends that you leave the base connected to its power source at all times, so that it is
always ready to use.
1.
Connect the power cable to the DC jack on the rear panel of the base.
2.
Connect the power cable to the power adapter.
3.
Plug the power adapter cable into the power source. The base is now powered.