Honeywell VOYAGER 1250G - Manual (Page 32)

2 - 8
Communication Timeout Beeper
This selection programs the scanner to issue an error beep when a
communication timeout has occurred. The error beep sound is pro-
grammed using
Number of Beeps – Error (page 3-4). Default = On.
NAK Retries
This selection limits the number of NAK retries that can occur in ACK/NAK
mode. Scan the bar code below, then set the number of retries (from 0-
255) by scanning digits from the
Programming Chart , then scanning Save .
(5 is the recommended setting.) Default = 0, or disabled.
Support BEL/CAN in ACK/NAK
This protocol responds to <BEL> and <CAN> commands when in ACK/
NAK mode. The scanner sounds an error tone when a <BEL> command is
sent from the host. <CAN> terminates the transmission.
Default = BEL/
CAN Off.
Off
* On
NAK Retries
BEL/CAN On
* BEL/CAN Off