Character deactivation mode, Deactivation character, Character deactivation mode -15 – Honeywell VOYAGER 1250G User Manual
Page 67: Deactivation character -15, Ed (see
Advertising
3 - 15
Character Deactivation Mode
If you have sent a character from the host to trigger the scanner to begin scan-
ning, you can also send a deactivation character to stop scanning. Scan the On
bar code below to use character deactivation, then use Deactivation Character
(following) to select the character you will send from the host to terminate scan-
ning.
Default = Off.
Deactivation Character
This sets the character used to terminate scanning when using Character
Deactivation Mode. On the
ASCII Conversion Chart (Code Page
, page A-4, find the hex value that represents the character you want
to use to terminate scanning. Scan the bar code below, then use the
to read the alphanumeric combination that represents
* Off
On
Deactivation Character
Advertising