Figure 3-49, Lan (dhcp) setup screen, Lan — dhcp – Honeywell HRHD 410 User Manual
Page 80
Configuration
Rev 3.01
62
Document 900.0315
10/05
Note
The system restarts automatically after changing the port
settings.
Note
Do NOT use the same port number for two different programs,
otherwise, the DVR cannot be connected with a PC running RAS.
Caution
When changing the port settings, you must change the port
settings on the PC running RAS as well. Refer to the
Remote
Administration System (RAS) User Guide
for details.
To save your changes and return to the Network Setup screen, highlight OK and then
press # . Select Cancel to exit the screen without saving the changes.
LAN — DHCP
Select DHCP from the Type box on the LAN Setup screen, and highlight OK to read the
current IP Address of the DVR configured by DHCP (Dynamic Host Configuration
Protocol) network.
Figure 3-49
LAN (DHCP) Setup Screen